|
For this project you will need:
- Yellow cardstock the size of 2 1/2 x 3
1/2 inches or 64 x 89 millimeters
- scrap piece of yellow cardstock
- rectangle piece of white cardstock 1/4 inch
or 0.5 mm smaller on all sides than the
yellow cardstock
- jumbo paper puncher with daisy motif
- small paper puncher with daisy
- yellow half bead
- sharp needle or pin
- soft underground like cardboard piece or fun
foam
- double sided adhesive tape
- 3-D foam tape or 3-D foam pads
- jewelry glue
- ruler
- stick glue
|
|
|
Instructions:
1. Take your ruler and measure about 1/4 inch from each edge of the white rectangle and poke evenly spaced holes along this edge.
2. Use your jumbo paper punch and punch the large daisy out of the top third of this rectangle, making sure to stay within the poked holes.
3. Poke holes also along the edge of the punched daisy. Glue the bead to the center of the flower and lay aside.
4. Punch 3 smaller daisies out of the scrap piece of yellow cardstock.
5. Adhere double sided adhesive on hte backside of the white rectangle and stick it centered on the yellow ATC.
6. Place a piece of 3-D foam tape on the back center of the daisy and adhere it to the card as seen in the photo.
7. Use stick glue and adhere 2 of the smaller flowers onto the card.
8. Place a piece of 3-D foam tape or 3-D foam pad on the backside of the 3rd small yellow daisy and stick it to the card.
|
|
